« SOFTMII 2.1.1 ON WII
FLEXPCB FOR INFECTUS ARGON MOD CHIP »

WII D2PRO PRE-SOLDERED ON WIICLIP INSTALLATION (BEGINNER)

So, substantially this is me instalment a D2Pro pre-soldered modchip into my D2C Wii. I never finished a modchip establish before so the full impact necessary digit hour.

This entry was posted on Wednesday, March 18th, 2009 at 2:51 am and is filed under Mod Chip Wii. You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

5 Responses to “WII D2PRO PRE-SOLDERED ON WIICLIP INSTALLATION (BEGINNER)”

  1. u cant cover up the hole

  2. I tested the chip before closing the wii ;-) YOu cannot see this in the video

  3. The only problem I see with this install is that you forgot to poke a hole in your tape so the DVD vent isn’t obstructed which may cause overheating problems

    and it’s always a good idea to test out the chip before closing the wii, there’s nothing worse than a bad install and not knowing until you put the wii completely back together.

    That being said, I hope you’re enjoying your chip =)

  4. after wrecking my wii trying to install a wiikey 2 on my D2c chip I went ahead and ordered a V4C3 clip for my wiikey 2, will get it in the mail as well as a new d2c drive i ordered off Ebay….fuck dont under estimate how small those bloody legs are on those D2c chips *If you are a newb do not attempt to solder on these they are a fucking nightmare! go with a clip youll save yourself a lot of hassle*!! :D

  5. GhostlyProductions on March 18th, 2009 at 2:51 am

    Good job! I just ordered the same clip and have never done modding b4, nice to know its not impossible for noobs :).

Powered by WP VideoTube