Comments on: WII D2PRO PRE-SOLDERED ON WIICLIP INSTALLATION (BEGINNER)

By: Zachintosh4

Zachintosh4 — Wed, 18 Mar 2009 02:51:02 +0000

u cant cover up the hole

By: funjail

funjail — Wed, 18 Mar 2009 02:51:02 +0000

I tested the chip before closing the wii YOu cannot see this in the video

By: steelbath66

steelbath66 — Wed, 18 Mar 2009 02:51:02 +0000

The only problem I see with this install is that you forgot to poke a hole in your tape so the DVD vent isn’t obstructed which may cause overheating problems

and it’s always a good idea to test out the chip before closing the wii, there’s nothing worse than a bad install and not knowing until you put the wii completely back together.

That being said, I hope you’re enjoying your chip =)

By: jesserai

jesserai — Wed, 18 Mar 2009 02:51:02 +0000

after wrecking my wii trying to install a wiikey 2 on my D2c chip I went ahead and ordered a V4C3 clip for my wiikey 2, will get it in the mail as well as a new d2c drive i ordered off Ebay….fuck dont under estimate how small those bloody legs are on those D2c chips *If you are a newb do not attempt to solder on these they are a fucking nightmare! go with a clip youll save yourself a lot of hassle*!!

By: GhostlyProductions

GhostlyProductions — Wed, 18 Mar 2009 02:51:02 +0000

Good job! I just ordered the same clip and have never done modding b4, nice to know its not impossible for noobs :).